Scarecrow Snap-Fit Molding Instructions:
Read all instructions
carefully before you begin so that you can familiarize yourself with the
fitting process! For best results custom fit each fang separately.
1) POSITION:
Look in a mirror and find the best position for the first fangs. Check the
angle front and back and side to side, and practice getting it into the
best position with ease so that you can locate it properly with minimal
adjustment. For the best fit, when the customizing material is in the cap,
you will want to be able to slip it up on your tooth accurately rather
than putting it up and then adjusting it into place.
2) MIX:
Pour powder from one capsule into the deep side of the carry case, by
gently twisting the capsule ends apart. Remove bottle lid, snap off tip
and dispense 7 drops ( for "Shredders" use 14 drops )onto the powder. Pick
up the case in your hand and tilt slightly. Stir with the stick provided
for 10-15 seconds until the mixture is uniform and just pasty while
keeping the material in a glob at the lower edge of the tilted case as not
to waste any.
3) FIT:
Scoop the glob of material into one fang, applying it onto the front and
back as evenly as possible rather than just filling up he cavity in the
fang. Gently push the fang all the way up onto your tooth, attempting to
locate the best position in one motion as discussed. Try not to wiggle,
adjust or reposition the fang after you push it all the way up. Leave it
on for 5 minutes so it can harden, but do not remove it yet, and dont work
on the next fang until 5 minutes has passed so that you dont
accidentally loosen it before it sets up. With the first fang in place,
position the next fang in a mirror. Orient this fang relative to the first
so that it has a similar angle and looks natural. After you practiced
putting it on accurately, follow steps 2 and 3 again.
TO REMOVE:
These fangs fit tight! If you like how they look after you finish
customizing, leave them on. When you are ready to take them off, gently
push your lower teeth forward against the backside of the fang tips until
you hear a slight click. The wiggle and pull gently with your fingers
until they loosen up. it may take a minute the first time you remove them,
they are meant to fit tight. Your fangs will now clip on and off easily.
If desired, trim off the excess material that shows on the front of the
fangs with a nail clipper or scissors.
TIPS:
If your fangs are well positions but you want them to fit even tighter,
customize again over the existing liner with a single capsule. You only
have to use one capsule to customize over the existing interline for BOTH
fangs. You an also crack out the interliner and start over for any reason.
CARRY CASE:
Be sure to clean the mixing vessel/carry case thoroughly by cracking and
scraping the customizing material out. The material does not bond to the
case but it may take a few minutes to scrape out completely.
|